Alfa Romeo Forum banner
madeno
1-13 of 13 Results
  1. 4

  2. 2

  3. 3

  4. 1

  5. Alfa GTV & 916 Spider
    Hi all I was wondering if anyone has fitted the Madeno Air Intake System shown below and what the experience and thoughts are about it, and Madeno in general. http://www.madenoracing.com/zdjecia/1/Image-0183____.jpg Appreciate all feedback. Best regards Thord
  6. Alfa GTA
    Does anybody know who produces these sets ? I have two leaking rear struts who needs to be repaired. I need to know the manufacturer to order the right serviceparts. I have checked the struts for any labels but the only identification I can see is "Madeno Racing Suspension Tecnology". I've tried...
  7. Alfa GTV & 916 Spider
    Sorry, double thread.
  8. Alfa 147, 156 & GT
    I am considering to fit Madeno Racing's steering wheel hub extender to my 156 Link. To get the wheel at the correct distance I would probably need the 60mm extender. But has anyone experience with the extender and can give an enlightened review of it? What needs to be done to mount it, is it...
  9. Alfa 147, 156 & GT
    Hello there, Let's start something new. I noticed a few kits with new bushes, rings, etc. for the different parts of the front and rear suspension on the site of Modena. Anyone with these fitted? What can you expect from these small parts (do they really make a big difference)? Will it stop...
  10. Alfa 147, 156 & GT
    hi guys.... just wanna to find out more about madeno racing produtcs...is there any member can share the info or any comment about madeno products ? thanks ..
  11. Alfa 147, 156 & GT
    Madeno Racing springs finally fitted (some pics) I finally managed to get my car in to get the 60.000 km service done and at the same time install the Madeno Racing lowering springs. I must admit that the car looks 100 times better than before. And it's still very smooth to drive. A lot better...
  12. Alfa 147, 156 & GT
    Do any have any experience whit the Madeno Chip tuning for an 1.6 Veloce. I have already read the story from Hugo whit the Autodelta remap. However, for me is Madeno only 25km from my home. Remco
  13. Alfa 155
    Last one, promise!!! Had a look at both Madeno (www.madenoracing.nl) and AW-Delta (www.aw-delta.de) and they appear to offer some serious manifolds for 2.0L 16V engines amongst others!!! Although I have contacted both, I guess that they didn't understand my questions in English and therefore...
1-13 of 13 Results
Top