Alfa Romeo Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 38 Results
  1. Alfa GTV & 916 Spider
    Hi. My leather insert in my door panel has come loose due to some broken plastic pins. Cant find any replacements Anyone know the part number or description of it? Attached a picture of the leather insert to remove any doubt.
  2. Alfa 147, 156 & GT
    Hi all, I am swapping my interior from the later black "ti" set that the previous owner had fitted, back to an early period, tan seat set which is correct for my '98 car. Seats are easy enough, however is it easier to remove the black leather inserts from the current door cards and glue the tan...
  3. Alfa 159, Brera & Spider
    Got one of the rubber stops off the bottom of the boot lid missing and would like to replace it. Its sits on a spring loaded piece of plastic, also on the look out for the rubber insert that fits in the door handle Cheers D
  4. Alfa 159, Brera & Spider
    Hello, I was detailing my new (to me) 159 today, and I managed to hoover out one of the rubber inserts inside the interior door handle. After going through the entirety of the Hoover bag I found it, and it's split in two. I spoke to a friend who works in Alfa parts, and apparently it's only...
  5. Alfa 159, Brera & Spider
    Hi all, I've just bought my first 159. The sidelight was gone on the offside when i bought it so i removed the nearside bulb just too check it was the bulb and not the wiring, it was fine. I've attempted to put a new bulb on the nearside but the holder won't come out enough to insert the new...
  6. South Africa
    Just drove past a youngster (I'm not old, but this oke must have been max 18) in the underground parking, standing proudly next to a polo, with the most atrocious body kit, and a ground clearance of about 50mm, if that. He was "skeefing" me as I drove past him, so I stopped, got out, and in my...
  7. Alfa GTV & 916 Spider
    Hi all, I'm toying with the idea of swapping the black fascia panel for a Ph2 silver one. So the questions are dead easy (I know no alfa question has a simple solution btw) 1) Can it be done? - if so..... 2) Do the heater controls, aircon and hazard warning switch and fog lamp buttons and...
  8. Alfa 159, Brera & Spider
    Hi I'm currently replacing/repairing/tidying my recently purchased 159 ti. So far I've replaced the plastic insert at the front of the boot and replaced a very tatty door card, next up will be replacing the grill and badges... Whilst cleaning the car this weekend I noticed I'm missing one of...
  9. Alfa 159, Brera & Spider
    One of the black inserts at the back of the ecu/fuse box (the ones that allign the cable connectors with the pins) is missing after an aftermarket alarm installation.Does any one know where can i find a replacement?:cry: Also what is the technical term for those? - there is nothing on e-per. Do...
  10. Alfa 164 & 166
    Any idea why the foam insert for here on the rear door should be soaking wet?
  11. Alfa Giulietta
    I am considering having a spare dash insert painted in red and I wonder why this part was discontinued. Any theories?
  12. Alfa 33, Sud & Sprint
    Hi folks, i have a Y reg sud ti with badly pitted front damper rods, my struts are the type with nut and screw on the bottom of the legs, with a circlip retainer beneath nut. Is there a special tool needed to allow insert removal on these struts? Ive also read here of some of you purchasing...
  13. Alfa GTV & 916 Spider
    Hi All, Is it anyway possible to remove the diagonally stitched insert on the doors,without removing the door card itself? As I understand it, it isn't but was wondering if anyone had an ingenious way of doing so... Ta.
  14. General Motoring Discussion
    Has anybody tried this kit ? Carbon fibre skinning kit - cover / wrap your own parts in carbon fiber - Carbon Mods Or know of somewhere than can skin a part for you? There's a LHD Alfa part but none for RHD .
  15. Alfa GTV & 916 Spider
    Has anyone got a spare insert that fits into the rubber seal where the doors closes on to the body. (Drivers side) that they would to sell. Mines had it and keeps popping off . If anyone has please let me know how much. Thanks Lynn.
  16. General Alfa Discussion
    Hi, Probably a silly question with a simple answer. I have just bought a secondhand Alfa Romeo 156 Jtd 16v M Jet Veloce Sportswagon. Both keys have the 5p sized logo insert missing. Any ideas on where I can obtain them? Thanks in advance. J
  17. Alfa Giulietta
    There's been mention of the carbon fibre insert only being available for LHD Giulietta , so I wrote to the supplier to Alfa , Zender Italy and got the inevitable reply; Good morning, "no sorry, we don't produce that parts for right hand rive cars, Cordiali saluti / Best Regards / Mit...
  18. Alfa Giulietta
    Received this yesterday and it fits the G's buckle, a temporary fix to get rid of the warning chime when parking, first service in Oct and will ask them to turn the whole thing off.
  19. Alfa GTV & 916 Spider
    Hi Alfisti I want to change the door card from my wrecked baby into my new baby who's drivers door card has several splits in it, However my first love has tan interior and my new lover has Black. How easy is it to change the leather insert on the door card? How's it done? Any advice most...
1-20 of 38 Results
Top