Hello fellows alfisti,
I'm currently reassembling my Alfa 75 V6 3.0 QV and I'm having an issue with the fuel management (Motronic 0 261 200 141)
The 6 injectors seems to be stuck open and let the fuel flowing freely into the intake even when the engine isn't cranking.
The injectors are fine...
What do people think of as within the normal range?
At idle and at 2000 rpm mine fluctuate about a bit but 2 and 4 seem to be below 1 most of the time whereas 1 and 3 tend to be closer to 2. These figures are under no load conditions measured with MES.
Is this considered within the normal range?
Hello, I am trying to find out some useful information about CR diesel timing, fueling and so and I figured here are smart people who may help me a bit :)
Google suggested me this forum many times so I decide to ask for help right here.
At begin I have to say my project is not related directly...
Hello friends, I wanted to know if it is normal that the duration in pilot injection is greater than 273 microseg, because when the car works perfect it has that time, but when it is with little power and the car heats more it works in 350microseg and its values escape of the map of maximum...
Back in 2001 when I bought my 147 1.6ts,it had a problem. There was a knock in the engine between 2000-2300 rpm (at this point I started wondering what a 'knocking sensor' is used for). The problem you might say wasn't that big, but the thing is that when driving in the city or going up a...
Ok got a couple of issues with the injectors I have looked online but don't find too many people with similar issues
I have put my engine back together injectors installed as per the E-Learn
Injector 1 - no fuel around injector or blow by
Injector 2 Over time fuel puddle and a couple of...
Hi there, Anybody got a source for the clips which attach the injection rubber hoses from the plenum chamber to the inlet manifold please?
The car is a '89 S3 Spider with Jetronic injection.
can somebody help me with calculations of EOI? It's for educational purposes. I need only for 50mg of fuel.
My calculations (for 50mg of fuel):
Does anyone know what circuit fuse F-11 supports? I've had this fuse blow with increasing regularity which results in the ECU putting the engine into limp mode. Also accompanying this is the usual gaggle of failure messages on the dash, ASR, hill holder etc.
Using AlfaOBD shows up a long list...
Good morning, I was doing some logs of my jtd 115 and I found the surprise that there is no pilot injection.
Does anyone have any idea of the subject?
I attach the capture.
Thank you very much, greetings.
Still trying to get to the bottom of the poor starting of the 156 JTD. I know that there are quite a few threads dedicated to poor starting with the diesel engines, although I believe that I have eliminated lots of things so I'm making progress! Glow plugs and relay are fine, fuel...
Good evening Guys
I had the Engine warning light come on the other day, and upon checking it said it was an EOBD Fuel Injection system failure, I arranged for it to be taken tot he alfa garage in glasgow. tHey said they cleaned the points and was a faulty switch which they changed and it was...
During a 340km round trip out of Sofia today, what the owner's manual identifies as "Avaria del sistema iniezionne" light came on (see pic) after about 60kms of motorway cruising. Google has kindly translated this for me as 'Injection system failure', which I take to refer to the fuel injection...
Hi, I have problem with injection light which turns on when I go above 3000 rpm.I have the 166 2.0 ts. If I drive normaal on the highway up to 120km / h ...1 minute later the light is there ... And alsow if i pull a little to 4 or 5000 rpm she can tolerate a few times but then the light alsow...
I have a 1984 Spider 2000 with the Bosh fuel injection.
Some hoses seems to have been changed but I would like to change all hoses relating to the airflow in the injection system as well as the smaller hoses relating to oil /fuel recovery system
The original rubber hoses measure 12 mm and 14...
Driving home from my friend's house tonight, I've come across an issue that the previous owner of my 166 told me he'd had in the past but that it hadn't done it for a while before he parked it up for 5 years due to other issues that I've now resolved.
The fuel injection system light has...
I have ran into something strange. I am unable to read my 05 GT's bosch ecu. Almost everything else i can check for errors except the abs, airbag and ecu unit. The tester checks for each module and then shows the modules. It shows the airbag and abs unit but says that it cannot...
My 1998 GTV 3.0 V6 has the key code light ON and the Injector Light OFF in the dashboard.
None of my keys can get the engine running. The "security" starts (pushing on the gas pedal with the code on the card) does not work as there is no injection light on the dashboard.
I have an intermittent problem on my S4 when it runs at speed (60-80 mph, usually on motorways). When lifting off the throttle, the car will judder as if it is misfiring, and I can feel this through to the back axle. Depressing the throttle usually clears this but sometimes it doesn't. The...