Alfa Romeo Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 402 Results
  1. Alfa 164 & 166
    Hi all On the hunt for a 166 3.0 clutch master cylinder (with fork on cylinder) and have so far only been able to find the ball end type. Anyone have one they're willing to part with or know where I can find one?
  2. Alfa Giulietta
    Hi everyone, recently I had a warning on my dashboard saying " Clutch overheat ...see manual" or something like this, and it started to smell a bit burned but that much. Is it a serious issue? How long can I drive the car or what's the issue or how to prevent it from happening again? Btw the car...
  3. Alfa 147, 156 & GT
    Hi guys, I hope you’re all well! I have a 58 plate 1.9 JTD Cloverleaf and a few months ago I noticed that on occasion the car judders when lifting the clutch up from down shifting. The judders vary in severity depending on the speed I’m travelling, and mostly happens when shifting down to 2nd...
  4. Alfa 159, Brera & Spider
    Hi All, I have a relatively intermittent issue with clutch pedal, seems to stick (can be pulled backup by hand (then is fine again) when pushed down hard (hard braking/stopping) gets worse after lots of use, then seems to be ok if left for a while again. Also accompanied by a creak sound when...
  5. General Alfa Classifieds Section
    Brand new & unopened clutch slave cylinder from Alfaholics. I bought this for a 72 GT Junior but it is no longer needed. Part numbers: CL004 - Classic Alfa https://classicalfa.com/cl004-clutch-slave-cylinder/ CLU004 - Alfaholics https://www.alfaholics.com/parts/105-series/clutch £35 free...
    £35 GBP
  6. Alfa 159, Brera & Spider
    My 159 SW is sounding a bit ropey at low revs & juddery when moving off. I am led to believe this is a clutch & DMF issue so was wondering where I can source a reliable 3-piece clutch kit & dmf without being too out of pocket. 1st searches indicate circa £800 to £900 just for parts. Any ideas?
  7. The Classic Alfa Romeos
    Hi all, hope you had a good easter. I have a new clutch slave cylinder, flexi hose & 2 retaining clips to fit to my '72 GT Junior. As far as I am aware the access is pretty good underneath the car. Before I crack on I thought it would be wise to check for any advice for doing so. Any tips on...
  8. Alfa 147, 156 & GT
    Hi Alfisti, Sadly were I live is hard to source parts for the 156 V6 and doing some research I found that on paper the CMC of the Alfa 155 TS has the dimensions of the 156 V6. Pump diameter of 19mm, 12x1 for the liquid hose to the slave and even the separation between the holes for the...
  9. Alfa GTV & 916 Spider
    at first the clutch was getting stuck half way to the floor, then nothing. i have rebuilt the slave cylinder and tried to blead out however there is only presure when the clutch is pressed quickly otherwise it falls to the floor. any ideas? cheers
  10. Alfa 159, Brera & Spider
    I have a 2011 159 2.0L JTDM 170bhp. Recently the hill assist brake came on twice while driving. Shortly after the second time it came on the brake pedal became spongy and then the clutch pedal became spongy and then stopped working. No leaks anywhere, the fluid from the reservoir isn't going to...
  11. Alfa 147, 156 & GT
    Hi guys. First post on here. I’ve got a 2003 147 2.0ts with a 5 speed manual box. So I was on the highway on the way to work this morning and geared down from 5th to 4th and when I tried to gear back up it wouldn’t go out of gear and there was an odd grinding noise. So I nursed it in 4th the...
  12. General Alfa Discussion
    It needs a flatbed with winch. It's street legal, engine runs fine for power steering and brakes, but there is no drive in any gear. Possibly a disintegrated clutch driven plate... Needs to be collected from Hanwell W7 and delivered to Autolusso, Houghton Regis during their opening hours...
  13. Alfa 147, 156 & GT
    Hi Everyone :) I've heard that there is a different clutch kit for the selespeed than the standard 2.0 in manual. Please tell me if this is true and which one should I choose? If it is possible and someone knows it, please give me part number :)
  14. Alfa 147, 156 & GT
    Hi, I'm new to the forum, I've recently acquired a 2001 156 with 60k miles, it's been running good for a month, but it has develop kind of a whining noise from the gearbox in neutral, when i press the clutch the noise goes away, it does not have any changing gears problem or difficulty, only the...
  15. Alfa 159, Brera & Spider
    Do you guys get a new clutch slave cylinder upon clutch replacement? My 159 has done about 104k miles and it has never had a new slave cylinder also it’s going to get a new clutch soon. My local garage is taking months to get it and I can’t wait soon enough anymore since the clutch kit is...
  16. Alfa 159, Brera & Spider
    Hi All, New to the forums 👋 I purchased a 2006 Brera 3.2 V6 Q4 MT a month ago and I've noticed the clutch pedal doesn't seem to come straight back up. When pressing down, it comes back 85% of the way but the last bit it seems to hesitate for two seconds. Also, when shifting between second and...
  17. Alfa Giulietta
    Hi, this topic has probably been covered before but looking for information to help me with the reliability of a remap. I have just purchased an Alfa Romeo Giulietta 2.0 jtdm2 veloce, 170hp. I have seen that remaps on these engine bring them to 210hp and 340lbs/ft of Torque. The car is...
  18. Alfa 147, 156 & GT
    Hi all, Sorry for the dumb title, I really don't know what the thing that broke off is called. As you can see from the picture, the Clutch arm has a black circular thing coming from the side of it, and there is a greasy metal ring that's popped off. Before it popped off or while it was popped...
  19. Alfa 159, Brera & Spider
    Hi! I've been having this clunking noise on my 159 whenever I release the clutch when on gear. I've had it for half-a-year now and I didn't think anything of it. Recently I had a really bad rock hitting the floor of my car and it had hit one of the engine mounts at the right side of the engine...
  20. Alfa MiTo
    Hi Ive had my Mito 155bhp TB for half a year now, and for the last month the clutch has been wierd. It occurs when i don’t change gears for a long amount of time (about 20-30 minutes). When i drive on the highway everything feels normal untill i take my exit. When i press the clutch for the...
1-20 of 402 Results
Top