Alfa Romeo Forum banner
cf2
1-20 of 195 Results
Advanced
  1. Alfa GTV & 916 Spider
    Help and advise sought. hopefully somebody knows. The story so far, I've had this spider for 5years, only 62K from new, the plan is to keep it for ever. previously had a GTV and spider, all 2.0 TS CF2's. anyway, Sophia (as she's called) was running fine prelock down, needless to say not many...
  2. Alfa GTV & 916 Spider
    Hello! I'm new here - owned a couple of Alfas but never posted on here before! Seeking advice.. Picked up a 2001 ph2 spider TS that had been sat in a garage for years. Changed all the fluids, got her running, but she started to knock... I suspected big end bearings... I'd assumed that the...
  3. Alfa 147, 156 & GT
    My Sportpack 2.0 TS CF2 is primarily a track day car and I am trying to source the best suitable parts for the rebuild. I was unable to source racing bearing shells and will use Glyco. I need piston rings, engine gasket and seals set and variator. Is there a competition/racing head gasket for...
  4. Alfa GTV & 916 Spider
    Hi folks Tired of being quoted £300 to cut out and weld in a new flexi as new twin cat front exhaust doesn't exist anywhere. I know some have gone down the modding cf2 front exhaust route. Can you share please how and where this was done? Im in the Thames Valley. Many thanks.
  5. Alfa 145 & 146
    Hey Alfistas! I just bought a renewed head (skimmed, new valve seals, pressure tested as i've been told) and a gasket set. Fitted it all together, all 4 cylinders have over 175psi pressure, starts and goes normally (okay, a bit more spicy, since i only had 2liter cams in good condition, the...
  6. Alfa 147, 156 & GT
    My "wonderfull" car developed strange problem once again. When the car is hot and you turn on aircon IT starts to cough and splutter until it stalls. ECU then throws p0650 Mil engine lamp fatal error. Things i've checked so far - earths points in cabin, under right headlight, main earth from...
  7. Engines (TS, JTS, JTD & V6)
    Could anyone tell me whether a CF2 16v head will fit on CF1 8v block?
  8. Alfa 155
    Could anyone tell me whether a CF2 16v head will fit on CF1 8v block?
  9. Alfa 147, 156 & GT
    Could anyone tell me whether a CF2 16v head will fit on CF1 8v block?
  10. Alfa GTV & 916 Spider
    Hi all! Just wondering, what with the rarity of new Idle Speed Actuators, if anyone's managed to transplant some other car's or third party throttle body on the GTV? What did you use and how hard was it to do? I've seen Alfa Workshop's 2.5 V6 adapter for Twin Spark engines, but never any more...
  11. Alfa 164 & 166
    Would cf2 manifolds from a 2.5v6 fit a 3.2? If so how do you solve the lambda sensor? Cheers
  12. Alfa GTV & 916 Spider
    As with most things electrical I quickly run out of talent. I know the knock sensors rarely go wrong and it’s likely to be a wiring fault but how is best to trace the fault? I believe Knock Sensor #1 is at the cambelt end. Sent from my iPhone using Tapatalk
  13. Engines (TS, JTS, JTD & V6)
    Hi all I have a 166 3.0 V6 24v cf2 engine for spares. Removed from a crashed car, most of the accesories still attached. Including rear exhaust manifold, alternator, starter motor, wiring looms, power steering tank and hoses, plenum and throtle body, coil packs, flywheel etc. Decided to keep...
  14. Alfa GTV & 916 Spider
    Hi, Well, after a pants drive down the M6 this afternoon I thought it was about time I made a start on the task of replacing both head gaskets. The front head is weeping along the front face near the water galleries. Only when the engine had cooled did this occur and rad-weld did a good enough...
  15. Alfa GTV & 916 Spider
    Hi folks, The time has arrived to replace the head gaskets on my 3.0 CF2 GTV. After spending several months getting the car roadworthy early this year, I was dismayed to find the front head leaking coolant (only when cold). The leak was from the area near the water galleries at the front of the...
  16. Tuning & Upgrades
    Hello i'm Michał from Poland my car is 166 2.4 jtd cf2 136 hp. I love this car and i thinking about more power i want 250 hp. This is my plan injectors from 1.9 jtd number 119 CR from 2.4 20v hybrid turbo 2260 exhaust 2.75 down pipe, and 2.5 pipe. Front intercooler, manual boost controler. I now...
  17. Engines (TS, JTS, JTD & V6)
    Hello i'm Michał from Poland my car is 166 2.4 jtd cf2 136 hp. I love this car and i thinking about more power i want 250 hp. This is my plan injectors from 1.9 jtd number 119 CR from 2.4 20v hybrid turbo 2260 exhaust 2.75 down pipe, and 2.5 pipe. Front intercooler, manual boost controler. I...
  18. Alfa GTV & 916 Spider
    Hi what is the correct gasket for the Cat to centre box? CF2. Just fitted a Alfaholics sports cat however a little blowey so have got new gaskets for join to downpipes, however not sure where to get gasket for other side of Cat. Triangle I assume slightly larger than the the ones that fit onto...
  19. Alfa GTV & 916 Spider
    Removed the air filter box yesterday to facilitate removal of the gearbox. Firstly the nuts and semi-circular bracket holding the MAF to the top of the air box lid are so corroded they won't release before turning the captive studs in the plastic. Is this going to necessitate a complete new...
  20. Alfa GTV & 916 Spider
    Over next few weeks will be clearing out a few bits and bobs as we move into spring. 1st up a set V6 - CF2 downpipes that were on my GTV prior to me getting new stainless steel ones, I found a set of Alfaholics downpipes for sale so could not resist. Thus in In good overall condition with...
1-20 of 195 Results
Top