Turned my 2.4 Brera on today to demist the windscreen and... nothing. The dual aircon display works perfectly and all buttons work etc but no air comes out whatsoever! If you listen carefully, when pressings the airflow arrows (window, face or feet) you can actually hear the airflow...
A quick search on the forum yielded no results, so here we go: how does one remove the 4 air vents from the dashboard? Specifically, the 4 round front-facing ones.
If I recall from the 159, it takes two J-shaped pieces of wire/metal and a firm tug to pull them free. Is it the same...
Evening all, I've recently changed my rocker cover gasket and since then when the car gets upto full temp I get a slight oil smell coming through air vents. I can't smell it when driving only when I'm sat idling at traffic lights etc anyone know what's causing this? Or had it happen to them...
I have a Alfa Romeo Giulia 2.2 180 cv diesel engine built on Nov/2017 and while checking the air filter condition, I've noticed that there is oil in the tube right after the air filter housing.
It's pretty similar to this thread from another forum...
Hello, maybe someone knows how to turn exactly Full-Auto on AR 159? there is two auto buttons but its only regulates temp and speed, so i want to switch from Auto to Full-Auto and i can see that Full word (it does not glowing red of course) before Auto in the screen. thanks in advance:) AR 159...
Hello everyone. Despite my best efforts to find a solution on this forum and the elsewhere on the internet, I've hit a brick wall with this one. My air con doesn't work and the fault has been diagnosed as my compressor needing to be replaced. So I provided my VIN number to several suppliers all...
Hi all, just bought my third Alfa and looking for some advice. Any appreciated. I believe this car has a timing chain. The engine sounds a little diesely (not a word but sounds right). Hasnt been serviced in a couple of years. Does the timing belt need replacing? Just looking at? or tightening...
Did some investigation today with AlfaOBD. If I disconnect the sensor I get water temperature reading stable 120C. If I shortcut the sensor connector it shows -20C.
I connected the sensor and started cold engine. I had not used the car for two days.
Outside air temp 17C, Cabin air temp 17C...
I drove about 20 yards today with the aircon blasting cold air over me. Then it just stopped, the fans stopped.
The controls panel was on but did nothing. Switched on and off everything but nothing!
Has this happened to you and what was the fault?
Howdy. I'm putting in a new lightweight fan and alloy rad and the fan kit control module needs a power source which goes on with the ignition and one that goes on when the air con starts (air con clutch)
Any ideas on the best place to tap into these?
If i roll down both back windows (front are up) and go above 50 mph, a weird "air" resonance occurs in the back. Quite unbearable, had to slow down/roll the back windows up, almost popped my ears :biglaugh:
Anyone else has noticed/experienced this?
Hi all, newbie here.
My wife has a MiTo twin air. Has anyone idea of how to check the oil? The dipstick is, well, oil coloured and I can't make any marks.
Are the marks the bottom of the thin bit for 'min' and the top of the thin bit for max?
Also, what is the volume between the two points...
I have a 156 2.4 150hp. Car has a fault code which suggests the intake air temperature sensor would be broken. Is there a sensor for it or is it built in to the maf? I have a new sensor but can't find it anywhere in the car and also can't find any information about it.
My A/C has never blown cold, so went for a re-gas yesterday .... but they said the condensor is knackered / leaking so a new one needed:disappointed: . Tried Alfa Workshop etc & they say they can't get new ones. Autolusso are going to get back to me. Google has come up with aftermarket ones but...
Hi still working on my air conditioning. Clutch doesn't engage but this could be lack of refrigerant. I'd like to check that clutch will connect so want to check at relay. Plenty of information about fuse numbers but nothing on relays. Anyone know the number of the relays location or where I...
Dear all, I have just gotten a 1.4TB (114kw/ 155bhp).
I like to have some sound on the turbo spool or oosh but not willing to have the one with open pod which is way too noisy and loud.
Just something better than stock will be good.
Will BMC or K&n be able to achieve that?
Hi any ideas how to fit adapter to air con pipe closest to brake/clutch reservoir. I have mito 1.3jtdm on 2011. Cant get a clean go at it sensor on bottom of brake fluid reservoir in the way which I'm a bit worried could break. Can I release pipe work and or manouevre brake reservoir Tia George