Carb set up
Can anybody help please
I am rebuilding a quad set of DRLA 45 for a rover V8 3.9l and need some advice please on correct float valve selection.
Would anybody be able to tell me what size float needle valve I should be using to ensure the engine does not lean out under heavy loads but also prevents the set up from running too rich at idle?
At the moment I have on order as set of 4 225,s on order, but on checking different forums what I should be fitting is very unclear
Will this size be OK ,or should I aim for a smaller size such as the 170 to ensure the carbs do not flood
(Note fuel pressure is set via a Filter King and is set at 2.5 psi)
Any help greatfull recieved
Best and kindest regards Al