got myself into a mess with my reply to you . After having a further investigation I find the 30A fuse I mentioned reads OK now i got the probes to contact the wire.Went back to the 10A fuse and that has no voltage either side of it ( Must measured the wrong fuse yesterday). Did a continuity check from pin 30 relay to base of fuse that was OK checked continuity to other side fuse still read OK So I am assuming this is fuse S47.
The colour coding of the wire from S47 is pink white and Pin 30 is Red both wires disappear into the loom in the bulkhead. Is it likely there is a connector somewhere in the bulkhead that might combine the wiring. It would be nice to get a diagram that will show the connectors . otherwise its a major strip out which I cannot do at the place it is stored
I would like a wiring diagram that shows the correct wire colour coding that could match my old spider or is this to much. I have got a pdf file access but cannot find a diagram to match
Last edited by Romek; 1 Week Ago at 13:33.