Alfa Romeo Forum banner

Looking for Driver Support......

Tags
support
677 views 7 replies 2 participants last post by  mr-mac 
#1 ·
#2 ·
I'm arranging to pick up the gauntlet from Gaz AONW) at Scaffel Pike and will shadow Fraser and Wullie from there to Fortwilliam, however, it'd be really good if AOS could turn out and show your support for an excellent cause at any of the stop-over or challenge sites. Once I've spoken to Fraser and worked out where we'll be and when I'll post up more info.

Thanks to all for anticipation of your support :thumbs:
 
#4 ·
Shouldn't you be off shaving you legs, or whatever it is you cyclists do :lol:

You'll be please to know the Hairy One has agreed to hand over the van, after some winging about it not being fit to drive all that distance. I told him it would probably not be doing more than 30 to 40 MPH at any point and all it needed was a service (Mechanics + Own vehicles = :rolleyes: ), so all sorted for Seathwate to Fort William. I'll need to take a closer look at your routes and try to mirror them as much as possible on the real roads, so as never to be too far away should you break a nail, or, the hair grows back on your legs :lol:

p.s. Your blog says 'both drivers are male', has that been established for Gaz?? :lol:
 
G
#6 ·
If dates suit and back is doing ok I'd be happy to offer any support Dundee - dunked - Dunfermline - near Aberdeen or if coming back via loch earn somewhere near there...

Just a broad idea if area I could easily help with and think back and neck would stand. I'll check other halfs shifts once you have route and dates\times on here :)

John
 
#7 ·
Hi John, thanks for the offer. All was sorted and the guys completed the last climb this evening. They can enjoy a nice train ride home tommorow and I will be returning their bikes, and gear back to their homes tomorrow before returning the van to it's owners at MGM services in Motherwell :thumbs:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top