Hi everyone
Finally got the gearbox and engine out but have a small issue. I have noticed that when I removed the old, knackered slave cylinder it seemed to have a rubber gasket that sealed the input shaft bearing from any dirt getting in. I have scraped off the remainder of the old gasket but the new slave cylinder doesn't seem to have this gasket? Have any of you used a gasket sealant before fitting the slave or did you just bolt it in? Cheers
Finally got the gearbox and engine out but have a small issue. I have noticed that when I removed the old, knackered slave cylinder it seemed to have a rubber gasket that sealed the input shaft bearing from any dirt getting in. I have scraped off the remainder of the old gasket but the new slave cylinder doesn't seem to have this gasket? Have any of you used a gasket sealant before fitting the slave or did you just bolt it in? Cheers