Alfa Romeo Forum banner

Clutch slave cylinder fitting question

625 views 3 replies 2 participants last post by  mshaw1980 
#1 ·
Hi everyone

Finally got the gearbox and engine out but have a small issue. I have noticed that when I removed the old, knackered slave cylinder it seemed to have a rubber gasket that sealed the input shaft bearing from any dirt getting in. I have scraped off the remainder of the old gasket but the new slave cylinder doesn't seem to have this gasket? Have any of you used a gasket sealant before fitting the slave or did you just bolt it in? Cheers
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top