Blue & Me - Display Not Changing

[breeonk]

Hi

I have recently had a problem with my stereo, when it is playing from the memory stick, the display stays at just Blue & Me, it does not display the name of the track etc... If I search for albums, they appear on the dash board as normal for me to check. I have reset the stereo but no change... Any suggestions.............

[SimonG]

Did you resolve this as I have the same problem at the moment

[DazJW]

I'd also begun having this problem in a MiTo recently and have managed to fix it by having a look at the various Blue & Me threads about resetting the system.

What you need to do is:
Get some needle nose pliers,
Make sure the keys aren't in the ignition,
Open the glove box,
Locate the fuses behind the glovebox on the left,
Locate the 10 amp fuse (there's only one, the rest have different numbers written on them),
Remove this fuse using the pliers,
Wait (I waited 2 minutes),
Re-insert the fuse (I used the pliers to get the fuse slightly into the hole and then pushed it the rest of the way with my fingers).

The system should now start showing the information on the centre console again.

Note that the car's alarm won't work until you have restarted the car (started the engine and turned it off again). The first time you start the car it will display the alarm unavailable message but after this it should be fine.

Also note that I'm not responsible for any damage or injury caused while doing this.

[webjames]

I can confirm either pulling the fuse referenced above, or disconnecting the battery does reset Blue&Me, however after a week or so my unit stopped displaying the track information again.

[SimonG]

Thanks for the update.

Weirdly, mine fixed itself - It's done this twice, so not sure what causes the issue to appear and then disappear again ?!
Cheers

Simon G