Heres my situation, Im trying to bleed the ABS pump of air following a brake caliper replacement. 1998 GTV 3.0 V6 (PH2)
I have MES 2.4, free/trial version.
I have the iDiagnostics KKL/VAGCOM cable, with the Green/Red/Yellow Adapters.
I have installed the iDiagnostics Drivers from their website, set the Latency to 1 from 16. Im running W7 64bit if thats any use.
The Issue is with MES i can do a Scan and it will find my ECU as a Bosch 2.1, It also finds the Harrison Climate Control Unit too. I can also connect to these, but as its the Trial it then kicks you out.
However it cannot find the ABS module. Now the ABS light comes on when i switch to MAR, and I know the ABS does infact work.
But it cannot connect.
When i attempt to connect, the ABS light comes on for a few seconds, then off, then comes back on for a shorter duration. Which indicates to me its not a fuse etc, but something else.
I am uploading a video to Youtube as i write this to include.
Does anyone know what i could try?