What's that noise
AO Silver Member
Join Date: Feb 2011
Location: United Kingdom
916 front and rear badge change instructions
Both are easy enough if you can find your way round a screwdriver!
Front grill badge open bonnet on inside of grill at rear of badge you'll see three rectangle retaining slide clips that's clamp on to the badge prongs that poke through the grill mesh. Carefully slide these off by prising with screwdriver. Badge should pop off and fitment is the reverse of the above.
Rear badge is slightly more tricky and I am assuming you have swivel badge. You're best off removing the entire boot lock mechanism which is simple enough. Open boot remove lining cover from lid. There is a locating lug on the internal rear of the badge that you need to rotate clockwise (I think) and it will unclamp the lock which you can then remove complete.
The swivel badge is held in place by a c shaped clip at rear of badge which you need to CAREFULLY remove. When removed the badge can be lifted out, again be careful as you can lose the spring. Fitment is the reverse of the above.
Good luck and use forum search function on here to add more detail on my comments above if you're struggling.
Back in the fold !