Over a barrel and putting the boot in!
Got round to wanting to fit my replacement boot badge today.
Anyway, to cut a long story short, I pulled the key out of the boot lock and it brought the whole cylinder with it! (This before I had done anything!)
As the key goes in I can see it moving the pins. However when I slide the barrel back into the apeture it remains 'loose' and no matter which way I twist it it just spins with no resistance and doesn't release the lock.
Typically the boot release solenoid is working but the unit has slipped so doesn't open the boot....
Im a little concerned as the wheel nut adapters, spare wheel and battery are in the boot!
Any thoughts on what to do guys?
Last edited by Alfa_Wurzel; 31-12-14 at 16:48.