Multi Ecu Scan - v odd airbag problem
I had to disconnect the passenger airbag isolater, move the seats (electric) and remove the glovebox over the weekend. When I put it back together I noticed the airbag light was on. No problem I though, done this dozens of time.
So Fired up the laptop and connected to Airbag ecu. I got a warning that the airbag ISO code was invalid, but clicked through that.
Checked error codes, there were 4;
Front crash sensor - interference detected
side airbag driver - value too high
side airbag driver - open circuit
ecu suplly voltage - value too low.
I cleared the codes no problem but the airbag light remains on.
The weird things is M.E.S thinks the light it out according to the parameters, see attached.
Any ideas, where the fault might be. I thought it might be the pass isolator but that is connected ok.
I'm used to the pretensioner suib faults, these ones are new to me!
2015 - Today 159 2.4 JTDm
2012 - Today GTV 3.0 V6 24v
Gone by not forgotten!
2013 - 2015 156 SW 2.4 JTD
2013 - 2013 145 QV Shed for 1 week - RIP
2011 - 2012 Brera S 3.2 V6 number 21/178
2007 - 2011 GTV 3.0 V6 Q2
Last edited by misterchase; 06-11-14 at 13:32.