So the permanent feature of a nice glowing airbag light has been the next job on my list, and I finally got round to getting my cable.
All connected to the ECU fine, and I have been given a nice long list of error codes related to the airbag (see picture).
I am unable to clear them using MultiECUscan.
I assume from this that the permanent fault codes will not clear until the fault is fixed, but I cannot even clear the intermittent ones.
I'm not really sure where to start.
The car is a Phase 2 V6, but it has Phase 3 seats.
At the side of each seat nearest the central console, there is a black cover, underneath which each seat has a yellow cable with a horrible 2 pin large connector.
Then underneath the drivers seat is another yellow cable plugged into a black cable. The passenger seat has the black cable coming out of the seat but no yellow cable to plug into.
Also a bit dubious about the 'control unit' faults it's showing up...
Any help would be much appreciated!