Refitting the heatshield tunnel
The heatshield tunnel was unscrewed to get the front subframe off, and the rear two bolts I carefully left in have dropped out so now the whole section is loose. The subframe is now back on but I can't get the tunnel to line up for fixing.
It is about 50mm too far back and doesn't want to come forward to line up with the chassis holes. I've put the handbrake down as far as possible but suspect the handbrake cables are causing the problem. Pulling & tugging it wobbles it forwards and backwards, so there's nothing hard stopping the alignment.
Other than removing the exhaust system, centre console, and dismantling the handbrake assembly, I'm hoping for a simpler solution so has anyone got any tips on how to get it back in position for bolting on again?