Just orderd the parts i need for my clutch. The 3 piece kit and Hydraulic slave from Shop 4 parts all for a bargain price.
I would like to try and install it myself, Is this realistic?
I was thinking of doing it this way:
Remove complete induction system
Passenger wheel off,
Passenger strut out and wishbone off
Disconnect driveshaft from gearbox and swing out of the way while still attached to Hub.
Disconnect hydraulics and linkages
Disconnect central driveshaft.
Support engine, remove mount from gearbox
Undo gearbox bolts and pull off gearbox
Swivel out from below.
Reverse procedure to reasemble (I am fitting new wishbones and Springs in the process).
Is there anything i am missing here or any issues i am likely to come across? I really don't want to remove the subframe as i don't want to risk shearing any bolts.
Is there anything you would recomend i do at the same time?
Thanks in advance