Powerflex bushes are good , but its not a very nice job getting the old bushes out ,the tie rod cleaned up then fitting the polybushes themselves . I did the front suspension wishbones on my GTV , it was a horrible job that needed patience and a lot of sweat .
I am hoping the engine mount should be fairly easier? I can cut out the existing rubber, do the powerflex bushes come in two halves then? I have never seen one before.
Yes the new bushes come it two halves.
The old rubber bushes are smaller and less complicated than wishbone bushes, shouldnt be too much hassle if you push the centre sleeve out with a vice/g-clamp, then cut through the rubber and outer sleeve with a hack saw.