Exhaust clamp near rear engine mount
I've been reviewing the manual, scratching my head and injuring my fingers all afternoon, and I cannot work out how to refit the part pictured (2 litre engine). Its a bracket with 2 bolt holes (one full and one half hole on the end) and attached to it is a bush with what I assume is half an exhaust clamp. It had a black wire attached to it (an earth probably) and it locates very near to the rear engine / gearbox mount. I've tried it in all sorts of configurations, but cannot get it to sit right with any studs / bolt holes.
If anyone has a pic or diagram of this in place, your advice would be very much appreciated.