<blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:<hr /><font size="1" face="Verdana, Helvetica, sans-serif">Originally posted by beerthunderman:
<strong>Thanks to the help in this forum I've managed to stop the V annoying rattle on my drivers window (take door panel off, tighten nuts holding glass to winder mech). Whilst I was in there I also lubed the slider rails with silicon lubricant (gloopy stuff used for joining push-fit pipes by plummers). The window now runs up like a good 'un
Thanks chaps!</strong><hr /></blockquote><font size="1" face="Verdana, Helvetica, sans-serif">Lucky you!
Can anyone give me advice on adjusting the window height? I read all the stuff I could find here and gave it a go at the weekend (door trim off, tighten nuts, etc) and while it's a bit better it isn't perfect yet.
So I guess the question is how much to adjust? I'm assuming that once I get to the bolts on the window which hold the blue plastic onto the window I need to loosen them off and move the plastic up a fraction? Do I just keep adjust a little, close the door, adjust a bit more, etc? Since both sides are out I'm not 100% sure where the right height is.
Oh yeah, and I'll try the silicon trick when I've got the door dismantled next time - good tip.