Join Date: Jan 2007
GTV V6 - HiFi motoring
|You are currently unregistered, register for more features.|
||Thread Tools||Search this Thread|
I would recommend buying the correct washing kit and oil as the CDA is too expensive to risk damaging. Likewise the AFM could get wrecked if you are not careful enough.
First remove and disassemble the CDA, then knock out all the loose dirt and vacuum clean the inside of the filter. Only then use the supplied solvent to clean up the filter and rinse in plenty of cold or luke-warm water. Shake it dry and then leave in the airing cupboard overnight to thoroughly dry. Then use the supplied oil to retreat the filter. Leave for a few hours to soak in and then wipe away any excess oil. Clean up the rest of the CDA kit and then reassemble, coating the joints with a thin smear of oil too.
Refit to the car, but leave out the AFM completely from the air-intake. If you can seal the intake without the AFM but leave the electrical connector in you should be able to get the car to run very roughly for a few mins. Only then fully reassemble the air-intake complete with AFM. This avoids any excess oil from the filter ended up ruining your AFM.
You could always use a spare knackered AFM in series for the same purpose.
If you have to unplug the AFM and run the engine the car will light the MIL Engine light and have a fault code which will need to be cleared, or may clear itself after 10 ignitions.
Finally remove the -ve terminal of the battery for 45 mins, then reconnect.
Turn the ignition on without starting the engine for 60 seconds without touching any of the pedals. Switch off and then restart the engine, again without touching any pedals. Leave to fully warm up and then take the car for a spin, recalibrating your engine to the way you want to drive.
Also worth cleaning the throttle valve at the same time with carb cleaner or a petrol-soaked squirrel pelt.
|afm , cda , intake|
|Thread Tools||Search this Thread|