at last i have all the parts needed to build up my hubs and brakes.
the issue has been that there is hardly 2 parts that are made to be together!
the full list that is going on my sud is;
alfa 33 front hubs,
fiat coupe turbo discs,
nissan 200sx turbo 4 pot calipers,
ebc yellowstuff pads,
15" alloys of 4x100 pcd.
the above has needed a few bits and bobs to get things fitting together,
caliper mounts made up to fit the 4 pots,
16mm aluminium hubcentric spacers to clear the calipers,
spigot rings to fit the non-alfa wheels,
wobble bolts to go from 4x98 to 4x100 pcd.
it's all taken a bit of juggling to get the clearance behind the wheel to clear the wider nissna calipers, only just cleared though by about 1mm!!
at least everything will be perfectly in line though. the hubcentric spacer fits over the alfa hub so it is central then the spigot ring fits onto that and inside the wheel so depsite the wobble bolts being used it will be 100% in line
have managed to chip a bit of paint off the calipers and wheels though
but once these are fully built up and back on the car then i can finally start to think about it getting off the axle stands, at last!!!!
i just hope the wheels don't foul the wings or i will need some more bodywork, shrew......