they are always available Adam, just on a one by one basis though, preferably built on the car.
if i'm honest, i barely dare discuss it following the attention it got last time, not your fault at all for raising it. i appreciate the consideration.
i won't be offering a group buy again for anything, but if someone wants my help, they get it, and if someone wants me to make/have something made, i do what i can.
what i will be doing is building my own manifold, an equal length stock layout, and if someone would like me to copy it for them, i'll put my car own on the ramp again, and repeat the build exactly.
like the BLS race one
benefit is there is a lot less creep from the bends when being welded up if its mounted hard at the heads rather than just bent and welded on the bench without a jig, making it easier to bolt up once it arrives, but downside is, because i built my full system to marry to my first crossover, there might be small adaptation required to meet another cars system, because my final manifold-system joint is a little off compared to a stock system's position because of the crossovers routing.
does that make sense adam? i'm not sure myself! ha ha!
in short, yes i can do them, but not quite as before, and not publicised or promoted in anyway via this forum
oops, did i just do that anyway