ok making good progress with SS039 since it arrived last thurs
Rad out & coolant drained & flushed ( via head drains) Expansion bottle off and cleaned as best as,new antifreeze & 3 new coolant hoses ( 1 heater pipe to t piece had NO clip
) As many hose clips as required ie LOADS !!
cambelts done ( refitted covers that i found in spare wheel well)- tappets all reset, plugs ,air & oil filter and NEW ENG oil ( hpx)
carbs cleaned ( will balance when back at work) all breathers blown out and cleared of oil etc.. dissy cap & rotor are fine ,new leads on order for this week,
new battery, whilst eng stripped and rad etc out i could access better , jet wash all inside engine bay
Sunday will see more general anal cleaning of eng bay grime and removing of heater box to clean and check bulkhead area ( battery tray still there and solid
) all fuel lines replaced with new clips.
Look into heater not working and replace some dodgey terminals to headlamp wiring and then stripping of brakes all round ready to take calipers into work to reseal and then put back with new pads all round ...... enjoy your sunday