What's the thread size of the oil pressure sender next to the oil filter?
Looking to fit a T adapter to refit the aftermarket electronic sensor I have.
I'd just like to try the sensor in a different location to see if the heat from the engine block is affecting the resistance of the sensor and cable giving me false readings. Appears to read lower pressure after about 15-20 mins of driving.
When the water temp reaches about 80 degrees (stable), I still have good pressure, but after some time after the engine bay heats up more the pressure is dropping.
Before I investigate the oil pump (pump 65 psi at idle when cold, even when the water temp reaches 80 degrees still reads about 40 psi at ilde), I want to place the sensor in a cooler part, off an adapter from the filter.
Last edited by brit01; 30-05-11 at 13:43.