Bit of a long shot, I have a project sud that already has a welded in cage fitted, it needs a fair bit of work though and its a 5dr.
BUT it is very very solid having had a few repairs in the past, the windsreec surround is rust free as are the inner wings, top rails, inner sills, outer sills. Ithas a new lower rear panel fitted. All it needs if your being picky is a small repair to the top of the rear panel (under the hatch seal. The shell is running 33 suspension so has out board front brakes and a hand brake on the rear. The boot floor has been removed as I was going to replace it with ally sheet. The doors have been lightened.
All the underseal has been removed so no hidden nasties underneath
The shell would come with the following:
Good low miles 16 valve engine
16 valve front cross member
16 valve front arms
16 Valve wiring loom & fuse board
16 valve ECU
16 valve under body fuel lines and main fuel pump
16 valve fuel tanks (mint)
16 valve manifold and complete exhaust system
Sud wiring loom (inc fuse board)
14 inch deep dish rev's with really good tyres
Set of Ti headlights
Sud Ti gearbox
Like I said its a major project but the basic structure is very good. I really don't want to sell but I have to accept that it will be years before I'll have the time to do it and I'd rather see someone else enjoying it.
I'm open to offers on £1000
I will put up more detailed pics if your interested i.e. inner wings, top rails etc. It has the potential to be an awesome car without feeling bad for modding a good standard sud