I have been in contact with a gent who has a few race type bits for sale anyway I said I would pass on the bits in the form of his original e-mail, if your interested I can pass your details on
His email goes- Seats, harnesses etc.
Assuming you are building a trackday special, you might be interested in this lot.
I have a pair of Recaros from a 33 16v - including mountings and runners - sitting at home, Alcantara in the middle, and something resembling leather on the outside. Driver's side is saggy and a little cracked in the usual places on the right hand side bolsters (although not VERY bad, centre bit is fine), while the passenger side is needless to say almost perfect. They have the under-thigh extenders, and came from a donor 16v with 87K on it. These can be swapped so the driver can have the good seat - I did this with Recaros from a Cavalier GSi many many moons ago...... £40 for the pair.
I also have two out of date six point 3" harnesses, one red OMP dated 2003 (might be 2004, can't remember exactly) and one red Luke dated 2009 which was only used once last year! I even still have the box. Both are from my 33 16v racer. £40 for the old belts, £75 for the newer ones.
Also, not sure how far you want to go with the seats. I have a black Sparco Corsa fibreglass race seat build dated 1999, and a bright blue Sparco Corsa fibreglass race seat build dated 2002. The black one is in my 16v, while the blue one is in the 16v that I am swapping my engine and box into at the moment. I have a brand new seat with ears for the racecar, so both of these are now surplus to requirements due to the constant rule-meddling............ even though at least the blue one is still MSA race legal. These are the ones with high squared thigh bolsters. £75 for the black one, £100 for the blue one.
If you are interested in a cage, I am scrapping my old shell. It's got an old cage without the fat roll hoop of a modern spec cage. However, it would be MILES better than no cage, and if nobody takes the shell it's going to be weighed in for scrap. To be fair, it is a welded in cage with a few trick bits particularly at the back - it's braced across the rear arches. I got it extended to the front turrets a few years ago by an FIA approved rollcage chappie, but had to cut a hole in the brace to replace a master cylinder before Silverstone last year.......tears were shed. I have a lot of stuff to strip out of it though, so it wouldn't be stripped and ready for a few weeks. I will get £50 from the scrappers for it, but it's yours if you want to take it away and save me towing it back to Telford.
Although my address is in Telford, I work in Reading during the week. I hired a shed in Reading to do the re-shell last week and brought my 16v down, so the black race seat and 2009 harness are here already. I can bring any of the others with me next week. I'm also picking up the new race car on Wednesday, so will have the blue seat in Reading from then. There may be a harness in that as well, but I'm certain it's out of date too and have no idea what condition it's in.