16V into a sud - Alfa Romeo Forum
You are currently unregistered, register for more features.    
Thread Tools Search this Thread
(Post Link) post #1 of 2 Old 07-04-08 Thread Starter
Status: -
AO Silver Member
Join Date: Dec 2006
Location: Kidderminster
Posts: 1,448
16V into a sud

16V manifold successfully modified to fit with inboard discs .
Took a bit of time and some head scratching but not too bad too do in the finish. Turns out that the outer / rear cylinder pipes clear the inboard discs and just the inners/ front pipes need rerouting.
Cut the inner legs off about 75mm before they go into 2. Welded a straight section on, to run pipe up inside of disc, other std pipe runs up disc outside.
Cut pipe about level with leading edge of disc.
Elongate the holes in the manifold flange to give extra turn and cut pipe off about 180mm from head.
Use a straight piece of pipe to get to by disc then cut a bend out of the pipe that had been removed to give a smooth rad bend between pipe from head and run down into manifold.
Weld it all together

Job done

Attached Images
File Type: jpg modfied 16V ex man 003.jpg (92.7 KB, 9 views)
RSFruitbat is offline  
Sponsored Links
Status: finaly on the road in the 6C
AO Silver Member
Alfasixnut's Avatar
Join Date: Dec 2007
Location: Market Harborough
County: Leics.
Posts: 2,827
Images: 17

Member car:

Ex 3 Sprints

Re: 16V into a sud

Nice job!
Alfasixnut is offline  

Go Back   Alfa Romeo Forum > Supported Alfa Romeo Models > Technical & Vehicle Assistance > Alfa 33, Sud & Sprint

16v , sud

Thread Tools Search this Thread
Show Printable Version Show Printable Version
Email this Page Email this Page
Search this Thread:

Advanced Search

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

For the best viewing experience please update your browser to Google Chrome