Hi everybody now please put your thinking caps on I have bought a new speedo censor to operate from the gearbox thinking I will get a result.
I have now bought a second Intstrament panel and it has not cured the problem.Can you tell me what the correct check for this is now
Have you checked the drive inside the gearbox to make sure its ok (if it has one)
Might be a Fuse
Hi Thanks for your reply,there is volage on the feed and a slightly less one ,say 4v or about there when static on the block from the sensor but nothing else I beleive there are four wires,I have been advised that the plastic drive should be checked so I will do this next thanks any way.ALFAPAT
I think there may be an issue with the instrument binnacle itself also. Both my rev counter and speedo are intermittent (fortunately the speedo works a lot more often than the rev counter rather than the other way round!). It seemed to help a little gently tightening the little bolts on the back of the circuit board for better contact.
Seeing as you've tried 2 units though I suppose it's unlikely both of them suffer from the same problem???