Posted this on AO.com, but thought I'd ask here.....(ie. JB
Hi everyone, I need your help.
I recently got a 75 2.0litre TS and it needed a head gasket. Dismantled the top of the engine and changed the gasket, however, putting it back together I have encountered the following problem....
How do I line the cams up properly ???
Cylinder #1 is at TDC, both distributers are sitting at #1 firing point, BUT, the mark on the flywheel is actually out by 180º !!!!
Because of this, I think if I put the cams in and line them up with there marks, they will be out of time as I believe they should be set at 10ºBTC. As the notch on the flywheel is round the other side, I can't see the timing marks.
What should I do ?????
Please help as I don't wanna bend any valves by doing it wrong.