V6 engine mount

Joss · #1 (**Post Link**) 29-11-10

The gearbox mount on the 2.5 V6 is knackered. I've managed to bodge the box braket to the 1.8 mount but the bolt is smaller and I needed to use loads of washers. The part is no longer available obviously but my local indi said it might be the same as the 2.5 V6 from the 156 or teh 3.o out of teh GTV. The bit I refer to is the round metal bit that's 3 inchs wide or so with teh rubber centre. its attached to the chassis rail by 3 13mm nuts. Any advice would be cool.

Ralf S. · #2 (**Post Link**) 29-11-10

My ePer is off the road at the moment.. (or rather the PC it's installed on is..

) but if you can get the part number, you'll be able to cross-reference it.

If AR has no more in stock, then you're looking at a second-hand one.. but if you know it fits a later car (e.g. 156) then your chances of getting a newer/better-nick one are improved.

Ralf S.

Joss · #3 (**Post Link**) 29-11-10

Yeah they did an eper on it and thought they were the same but wanted to make sure

Ralf S. · #4 (**Post Link**) 03-12-10

The ePER jobbie has a Search facility. If you put the part number in you get a list of all the cars that use it.

Ralf S.

Joss · #5 (**Post Link**) 03-12-10

Was just about to report back. Tis fixed. the guys at ICSR got it out

Can use the original one now

New To Site?	Need Help?
Register to Participate The AO Staff Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read

Did you know..?
	Within your User Control Panel, you can change the way AO works: For example, to change the number of posts per page, go to Edit Options and scroll down to 'Thread Display Options'. In the section 'Number of Posts to Show Per Page' select a desired amount.