AO Silver Member
Join Date: May 2009
Hi djh I have done this and if you are going to do it I really do hope you are a patient man because it can be a complete nightmare as I found out. One thing I would say is the first thing you should do is get some masking tape and put it on the windscreen in line with your wiper, either above or below it, so when you refit the blade section its not in the wrong position. If it is you might end up with the problems I had which is the wiper either going off the windscreen completely when turned on or the edge of the arm hitting your bonnet. It took me a while to get the right position. The other thing is be careful removing the 5 screws in the rubber seal because you can easily drop them so use a mgnetised screw driver but when I was taking them out a lot of the rubber came out with them and was in the screw thread so that made it hard to get them back in right. TBH to fix the prob you are gonna have to do this but just TAKE YOUR TIME.
Dont bend the rules, Rule the bends