Rear brake pIads
I am running into some major problems when replacing my rear pads. Short story: took off old pads and by mistake throw them in the bin.. Have new EBC Yellowstuffs to put in, but then problems start.. Have cleaned the pad carrier surface down to bare metal, but when installing the anti-rattle clip, the fit is too tight, the pad will not fit. Without the clip it goes well, almost too much slack. I also bought a pad fitting kit, the metal guides supposed to fit in the carrier, that does not fit at all, and none were installed before either.. Now the weird thing starts, because when checking on ePer, my carrier is not shown for any 156 model..!? I think the number on it is CH6 Lucas 5370/2 or 5390/2 Have done research on the net, but no solution. Only thing I can think of, is that this carrier is from an other Alfa-model, maybe from the 145? Btw, the caliper is correct, the early version aluminium Lucas-type. Please see attached photos of the carrier/pad. Will be greatly thankful for any advice here/what to do. Thanks in advance!