I have a 156 JTS and have managed to fit new clutch and CSC, and just before i start the timing service, i thought... The clip for the Concentric Slave Cylinder: does it go North south, or east west? Also as i tried to bleed the clutch with a vacuum bleeder, it was sucking alot of air, like the seals on male connector were way too loose.
1) should i fit the clip ( in a weave pattern it is designed, out in out) before putting flex hose in?
2) should i fit flex hose, then fit the clip over?
3) do i fit clip when male connector is at narrowest, half way?
I know this is a stupid question, but i find it's the trivial things that catch me out!
Had a look at old CSC and i have put clip horizontally, by mistake or not.
On plus side clutch pedal is returning properly, so BIG SMILE.
Thank you once again, in advance.