Join Date: Feb 2006
Location: Gretton, Northants
HELP?? 2.4 JTD RPM Sensor disconnect?
I'm trying to replace my rpm sensor on my 156 2.4 JTD (2002) but cannot disconnect the electrical plug.
It's right up the back and can only get 1 hand up there.
Anyone know how the plug comes apart?
Surely not just pulling on the wire? First I have to get the wire out of the white nylon grip ??? I'm stuck
Thanks for advice on how or where to find out how.
Good Griefs, I done it - almost.
There is a locking clip and the only way to release it is with a small screw driver to lift it. Pressing on the proper part with my finger did nothing. Came off in the end quite easily but only after I released the whole connection from the plastic clip on the back of the block. Don't do this as it's proving v. difficult to get back. However, engine runs now and I hope this will put an end to the stopping on the road.
Last edited by Jeronimo; 01-12-07 at 16:23.