Drivers side driveshaft 3.2 GT
Hi bit of a saga and still not any light at the end of the tunnel so here goes story so far
cv boot rubber went and I was a bit slow getting it sorted left it too late and the dreaded clicking started on full lock
Booked it into my local Alfa dealer and they put a new boot on but was too late
Got a quote from another local garage for just doing joint for £168 fitted pattern or £380 for a genuine shaft
Decided to go down the pattern part route but the part the dealer ordered wasn't correct.
Then I ordered the Alfa part only to be rang back 15 mins later saying the price they quoted was incorrect and that it was £120 more to pay
Decided to get refund and found on eBay some 3.2 cv joints so ordered one and total cost £25
Item arrived and that didn't fit either !
Then I rang Autolusso and ordered a complete 2 nd hand Shaft arrived next day reasonable price and 3 months warranty booked in today and just got off the phone the garage informed me the splines are not correct on the gearbox side ARGHHHHHH
My cars a 3.2 GT it has been fitted with a Q2 diff so not sure if this makes a difference
I will ring Ned from Autolusso tomorrow but if any body could enlighten me as to where I'm going wrong I would be greatful
Thanks in advance for any info supplied