new clutch fitted incorrectly?
so I had the clutch changed on my 57 gt jtd over the weekend. Was by a local mech, known him years worked for vaxhaul for over 15years so knows what he is doing is!! my clutch went and from my description on here was likely the trust bearing. any ways he stripped her down and got at the clutch. was indeed a metal clip that on the side of the bearing had snapped off. so he changes out the clutch and reassembled. still the same tho. won't select any gear feels like clutch not separating. so he re stripped and re did. went back together and this time did work but felt wrong. very difficult to get into a gear eft then ten miles into a test spin goes again. on flat level ground will go into reverse but you have to hold it on the break as just wants to pull away even though clutch pedal is flat to the floor. any one any thoughts on what's happening? for other info it selects gear fine when off, can start it in gear and drives okay, he also changed the slave and master so not those sure either.