hmm where to start
tidy engine/complete modded intake runners/make cooling pipes to go round turbo to fit rad/complete the remake of the manifolds to turbo exhaust /move wiring to fit oil cooler and intercooler / make all the plumbing for the turbo .
similar.. make exhaust manifold inlet manifold and paint all covers
Then finish de rusting and undersealing / refit subframe etc etc]
Dinitrol all box sections and underneath
when thats done its time for new wishbones/suspension / disks calipers and pads (front)
Then rear disks & pads and springs and ARB
new coilovers eibach bars adjustable drop links and adjustable rear bars with strut braces all round
feed turbo gauge hose through to inside car then refit gauges replace info center plus some other messing about.
fit loads of interior back in...
when all thats done
Remove wings and zender kit from other car.then put wings on car and wing from project car to other car. remove rear bumper fits kit prep and spray. then refit to car.
same here remove front end respray refit
then its just finish building the exhaust from turbo to cats and fit performance back box.
full exhaust and fit the new wheels from a different car wit wrong stud pattern and offset lol
nearly done just touch screen in car stereo and amps subs etc.
just sub box to finish rest of the stereo is in
finally battery to boot conversion . and pop around doing the bits i forgot to do
few of those too
then start looking for a another engine to rebuild completely with upgrade parts so it can take high boosts ( which ill just do over time )
building a 3.8 n/a started collecting the bits...
then plan a trip to go pollute the beautiful welsh country side with the beast
I pollute it every day lol.. hope to do it some more
all should keep me busy for a while