These last few days in my GTA is coming out an error, "Selespeed system failure", only for a moment, the engine is not in emergency mode or anything just goes on and off after a few seconds.
I cleaned the 10-pin connector next to the battery and the battery is new (Bosch 60Ah S3-560 cold start) but still goes out and always with the car running, never to start the engine.
I connected the Alfadiag and says this:
Failed Component Code: Clutch Range Sensor
Fault Symptom: Short Circuit VBatt
Warning Lamp Status: Warning Lamp Illuminated
Fault Test State: Test complete for this Error or not applicable.
Fault Code Storage State: Error Not Present at time of request
Event Count: 2 count
Environmental Condition One: Hydraulic Pressure: 46 bar
Environmental Condition Two: Engine Speed : 1696 rpm
Environmental Condition Three: Vehicle Speed: 50.76 km/h
Environmental Condition Four: Gearbox Oil Temperature: 70.4 °C
Environmental Condition Five: Requested Gear: Fifth
Environmental Condition Five: Inserted Gear: Fifth
Environmental Condition Six: Battery Voltage: 13.49 volts
I suspect that is the clutch sensor connector because I once spent four years ago, in the leader changed it and still giving the error. I've been manipulated without disconnecting it and for about 60 km. has not been re-produce the error. Any suggestions?
Thanks and regards.