Re: Selespeed info
First selespeed issue tonight on my 156. I was decelerating down a long downhill slip road from about 60, as I was at about 30mph or so, i looked at the gear display and it was in N. Pushed the lever forward and it went into 3rd and pulled away as it should. A few minutes later, again slowing down without brakes up to a roundabout ( in CITY this time), it did the same again. I was almost at a standstill, display showed a steady N, car went into first as I pushed the lever, and off it went again.
i just checked the selespeed fluid, a tiny bit low, but above the Min mark. All gears will select with engine off ( key at MAR) and brake on and when it drives, gear selection is perfect.
Is this the start of something nasty or a simple fix?
I just downloaded Alfadiag and the cable should be here in a day or two so I can check out as much as I can then.
Looking through the Selespeed fault chart, looks like most problems like this, if not low fluid, are electrical connectors.
I did drive through a lot of rain yesterday, any suggestions?