would much appreciate some help with an error with my Selespeed this morning. This happened:
Drove as normal for maybe hundred meters. Selespeed gearbox light started flashing, gear display flashed and was showing 1 and 2 (driving in 2nd gear). Buzzer also, I think. Slowed down and drove around the block, started and stopped, also tried citymode. No apparent issues, but the gear indicator display (from now on 'display') was blank. I parked the car and started diagnosing..
-When I put the ignition on, the sele lamp is flashing, the display lights up (all symbols) and then blacks out. I can change gears and start the car.
-Diagnosis shows no stored error codes!
. I can read the gears in MES when changing between 1, 2, N and R.
-Selespeed oil needed topping up (100 ml or so) (was replaced last year)
-Large selespeed connector was opened and cleaned
-Battery was disconnected for 1 hour
-Clutch rod position is 30.6 mm
approx. (should be 28 mm, I know)
-Pressure and pump priming seems normal, but the pressure still drops to 42 bar before the pump starts (ref http://www.alfaowner.com/Forum/alfa-...cumulator.html
What can I do next? Clean the sensor connectors? Check battery voltage? Could clutch rod position give this type of error?
Help much appreciated!