How to remove and fit rear abs sensor on 147
Hi, I need to remove the abs/wheel speed sensor on the offside rear of my 147. I've undone the 10mm bolt and had a go at prising the plastic backing of the sensor off but in my attempts the thing snapped in half! I've had a pull at the cable and I can see two wires but nothing else and it will not budge. On the other side I have looked through the hub thread holes and can see the sensor through there, had a go at tapping it through but it still won't move. I don't need the old sensor so should I just tap it through and break it up and pull the cable through from the other side? How do I fit the new sensor is it just a case of cleaning the hole up and pushing the new sensor through and then doing the 10 mil bolt up?