Okay got the lead yesterday. Took about 5 minutes to install the software/drivers and ports connected straight away. This is what it said
Boost pressure sensor A circuit low. Check the following:
- Turbine actuator or turbine faulty
- Supercharging pressure sensor out of calibration
- Atmospheric pressure sensor (inside control unit) faulty
The reason for this fault is that ECU has received invalid signal from the sensor. The fault is not detected now, but it is stored in memory. Clear fault codes, and observe for future appearance of the same fault. Dashboard warning light was activated for this fault.
Engine temperature: 88.1 °C
Engine speed: 4071 rpm
Fuel quantity: 65.4 mm³/i
Gas pedal position: 100.00 %
Fuel pressure: 1610 bar
Boost pressure: 2880 mBar
So probably because I was booting it a little...
Cleared the error and engine light gone! All normal now.