i have been writing to you for getting some help with my actuator and clutch replacement.
now im here:
so i found that i have messed up putting back on the actuator. The hex bolt inside was wrong. i fixed it with a mirror this time so that i now know it is 100% correct.
i bleed the clutch2 times, and ran the actuator base adjustment, both successed with the error status 00, which i believe is good???
when im trying to run the production/service final calibration it writes: error due to absence of suitable conditions and wont go on. im having these 2 errors which i believe is the reasson for it to fail?
P1741 - Engagement sensor / signal high Fatal
P1742 - Selection sensor / Sgnal low Fatal
ne sensor was broken when i got the actuator so i switched it, so i changed it but had my doubts about which way to twist the Little sucker.
when i tried to change gear it went from N to 1 to 2 back to 1 and to R no problem (alo
ittle slow) aftes 2 attemps it wouldnt go into R anymore?
So let me hear what you think.