Just wondered if to bleed the slave on the 147 you release the clip then pull the pipe out to the first notch then pump the pedal or is it a different method ? Does it need to be running or not?
Any advice would be great
I did it alone, but only by pushing the feed pipe back in after every downward pedal stroke, then running around to pull up the pedal, then pulling the pipe out, then running back and pushing down the pedal, then ... well you get the picture! Luckily it didn't take too many goes. I was clearing the old fluid out after replacing with Castrol Performance so I'd all but emptied the reservoir.
I did it what I did was put a pipe on the nipple and into a container then topped the resovoir pulled the pipe back to the first point, then pushed and pulled the pedal and left it for 10 mins whilst doing other bits keeping the resovoir topped up and it gravity bled then pumped the pedal gently twice then pushed the pipe in and hey presto