Another Airbag Thread
Hi folks.Have a '99 V6 of which the airbag light is on (bought it like this). So whipped out MultiECUScan with the cable Rarebear provided and found the fault to be passenger airbag circuit. Sooooooo had a nosey under the seat to check the connector, clean and reseat it........only to find.........the one connector (the one from the floor wiring) is ummmm.......non-existent.
Somebody had previously tried to solder things together again, but I can't find the connector (to try and resolder it back in). Ideally I'd like to get it fully operational and not fudge it by using a resistor.
Cables from the floor are coded 'White & Green' and 'White & Blue', while the connector block on the seat has wires Blue, Brown and Black. Question is, what is the combination for soldering the floor wires to the seat wires (assuming on of the ones for the chair will be ground)?
Any help will be greatly appreciated (as always).