HELP, Clutch Hydraulics still has issues.
After replacing a blown Master clutch cylinder last week the system is still not working properly.
With a firm stamp on the clutch it will disengage and change. the pressure also holds while the peddle is pressed. However if you gently press the peddle it travels to the ground with no resistance and stays down. the clutch does not disengage. you then have to hook your foot under and pull it back up.
I thought i hadn't bled the system properly and air was in so today i re-bled it with new fluid. there was some air in the system. However after running the new fluid in completely the problem has reoccured almost instantly.
On further inspection of the system i can see the pipe from the break fluid is kinked flat. this is due to the angle of the pipe to the cylinder, its on correctly! could this be the issue? is this the wrong cylinder with a longer pipe push( i don't have the old one to compare )
any other ideas?
How about I get you a spoon, so you can eat my A*s!