Right I have got the subwoofer fixed to the rear of the seat as its the most convenient place for me to have it (See second picture)
And I have routed the power cable through the bulkhead next to the bonet release cable (After much swearing)
Now this is where ive hit a snag.
I knew my Headunit (Blaupunkt Los Angeles MP72) had preamp outputs and I was under the impression these were on the rear of the headunit.
That was my first mistake, I need a seperate cable for the outputs but im not sure which one is the correct cable to use.
Below is a link to a page with the available cables:
The pinout diagram for the headunit is as picture 4 below.
I think plug C-1 is for the pre-amp outputs, is this what I need to use ?
With the first cable on the website above ?
Or do I need to use a cable to connect to the sub-out "pin 3" on plug A ?
Using the 5th cable down on above website ?
I intend to connect headunit to the sub/amp using RCA (Red/White) leads...
Also can anyone tell me which is the remote turn on pin on the Headunit for turning on the power to the sub/amp
Hope this makes some sense